Pressix CC 41 - Channel System
Clamping End SKL
Application
Mounting element to be fixed within the flanges of I- and U-shaped beams. The systems (such as pipes, etc.) supported this way may run parallel or at right angles to the direction of the I or U beam.
Also suitable as support for crossbars between two vertically adverse arranged profiles.
Scope of delivery
Pre-assembled
Installation
The tightening moment of the clamping bolts must be between 1 (minimum) and 1 1/2 (maximum) turns; then tighten locking nuts.
Note:
The length of the channel to be cut : inside diameter of beam less 25 mm
Technical Data
Permissible load per set: | Crossbar support: (2 sets) 5.0 kN/crossbar Single attachment: (1 set) 2.5 kN |
The maximal torsional moment of the channel is to be taken into consideration.
Material: | Cold-worked steel, electro-galvanised |